| INVERTER PART |
| Supply Voltage (VPN) | Applied between PNU, NV, NW | 500 | V |
| Supply Voltage (Surge) (VPN(Surge)) | Applied between PNU, NV, NW | 575 | V |
| CollectorEmitter Voltage (VCES) | | 650 | V |
| Collector Current (IC) | TC = 100C, VDD 15 V, TJ 175C | 60 | A |
| Collector Current (Peak) (ICP) | TC = 25C, TJ 175C, Under 1 ms Pulse Width | 120 | A |
| Collector Dissipation (PC) | TC = 25C per One Chip | 454 | W |
| Operating Junction Temperature (TJ) | IGBT and Diode | 40175 | C |
| Operating Junction Temperature (TJ) | Driver IC | 40150 | C |
| Short Circuit Withstand Time (tSC) | VDD = VBS 16.5, VPN 400 V, TJ = 150C Nonrepetitive | 3 | s |
| Isolation Voltage (VISO) | 60 Hz, Sinusoidal, AC 1 minute, Connection Pins to Heat Sink Plate | 2500 | Vrms |
| Junction to Case Thermal Resistance (Rth(jc)Q) | Inverter IGBT part (per 1/6 module) | 0.33 | C/W |
| Junction to Case Thermal Resistance (Rth(jc)F) | Inverter FWD part (per 1/6 module) | 0.76 | C/W |
| Collector Emitter Saturation Voltage (VCE(SAT)) | VDD = VBS = 15 V, VIN = 5 V, IC = 60 A, TJ = 25C | 1.80 (Typ) | V |
| Collector Emitter Saturation Voltage (VCE(SAT)) | VDD = VBS = 15 V, VIN = 5 V, IC = 60 A, TJ = 175C | 2.20 (Typ) | V |
| FWDi Forward Voltage (VF) | VIN = 0 V, IF = 60 A, TJ = 25C | 1.90 (Typ) | V |
| FWDi Forward Voltage (VF) | VIN = 0 V, IF = 60 A, TJ = 175C | 1.85 (Typ) | V |
| High Side Turn-on Time (HS tON) | VPN = 300 V, VDD = 15 V, IC = 60 A, TJ = 25C | 0.80 (Typ) | s |
| High Side Turn-off Time (HS tOFF) | VPN = 300 V, VDD = 15 V, IC = 60 A, TJ = 25C | 1.35 (Typ) | s |
| Low Side Turn-on Time (LS tON) | VPN = 300 V, VDD = 15 V, IC = 60 A, TJ = 25C | 0.65 (Typ) | s |
| Low Side Turn-off Time (LS tOFF) | VPN = 300 V, VDD = 15 V, IC = 60 A, TJ = 25C | 1.20 (Typ) | s |
| CONTROL PART |
| Control Supply Voltage (VDD) | Applied between VDD(H), VDD(L)COM | 20 | V |
| HighSide Control Bias Voltage (VBS) | Applied between VB(U)VS(U), VB(V)VS(V), VB(W)VS(W) | 20 | V |
| Input Signal Voltage (VIN) | Applied between IN(UH), IN(VH), IN(WH), IN(UL), IN(VL), IN(WL)COM | 0.3VDD+0.3 | V |
| Fault Output Supply Voltage (VFO) | Applied between VFOCOM | 0.3VDD+0.3 | V |
| Fault Output Current (IFO) | Sink Current at VFO pin | 2 | mA |
| Current Sensing Input Voltage (VSC) | Applied between CSCCOM | 0.3VDD+0.3 | V |
| Quiescent VDD Supply Current (IQDDH) | VDD(H) = 15 V, IN(UH,VH.WH) = 0 V | 0.40 | mA |
| Quiescent VDD Supply Current (IQDDL) | VDD(L) = 15 V, IN(UL,VL,WL) = 0 V | 4.80 | mA |
| Operating VDD Supply Current (IPDDH) | VDD(H) = 15 V, fPWM = 20 kHz, duty = 50%, applied to one PWM signal input for HighSide | 0.48 | mA |
| SYSTEM |
| Storage Temperature (TSTG) | | 55175 | C |
